![]() ![]() Receive notifications of new posts by email. Since the configuration steps are really simple (only the gateway, groupname & -password are needed), I am not showing them here in detail. Here are two screenshots of both variants from the iPhone. Palo Alto GlobalProtect is a virtual private network (VPN) solution that enables encrypted access to protected resources. It uses the IKE and ESP protocols (instead of SSL) to connect to the Gateway firewall. Ive been trying to rollout the GlobalProtect VPN software to our end-users and after verifying them as a user. So, if only the mere VPN connection to the internal network is needed, the built-in IPsec VPN-Client from Cisco fits completely. Step 1: Download and install the GlobalProtect Clientless VPN dynamic update GUI: Device > Dynamic Updates > Check Now > GlobalProtect Clientless VPN > Download and then activate after the download completes. However, it requires the GlobalProtect Gateway license. With this app, options such as HIP profiles can be used, the best Gateway can be determined after a connect to the Portal, etc. In order to have the best performance and configuration possibilities, the GlobalProtect app from Palo Alto should be used. In order to use the native Cisco IPsec client on iOS, the “X-Auth Support” must be enabled on the GlobalProtect Gateway, such as shown here in my post about the Linux vpnc client. This document provides information regarding the use of the Custom SSL VPN Configuration on MobileIron Core and MobileIron Cloud to configure the Palo Alto. Here is my attempt at the custom parser: id26000 namePaloalto VPN Client COnnection Succeeded matchSYSTEM matchglobalprotectgateway-auth-succ matchUser. The GlobalProtect app from Palo Alto works without any problems if a correct Portal and Gateway are already configured.
0 Comments
Leave a Reply. |