This could cause too much water to enter the tank. Your Water Softener is OldĪn old water softener system may degrade to such a point that its components can’t do their jobs properly. To amend a float tank that’s too high, follow the instructions in your user manual to set the float valve to a lower level. The brine tank’s float valve controls how much water is in the tank at any time. This is the easiest and least threatening problem to resolve. If your tank’s water is alarmingly high, or – even worse – overflowing, here are the likely reasons why: Your Float Valve is Set Too High However, one of the most common water softener problems is too much water in the brine tank. You can avoid salt bridge formation altogether by making sure the water softener is stored in a non-humid location and only adding salt to the fill line in the tank.Ī water softener brine tank is supposed to contain water – that’s what dissolves the salt to form a brine solution. Simply use a broom handle to knock the salt bridge into pieces, then fish the pieces out of the water using a net or a cup. Once you’ve identified a salt bridge, it’s easy enough to remove. Salt bridges form when the brine tank is stored in a high-humidity area, or the salt levels are too high for the tank. Salt BridgingĪ salt bridge is by far one of the most commonly experienced water softener problems.Ī salt bridge is a hard, crusty formation on the surface of the salt level. ⚠️ Most Common Water Softener Problems 1. Use resin cleaner in the resin tankĬheck for salt bridge/ mushing and remove clog Replace if necessaryĬheck manual and follow instructions to set valve higherĬlean system plumbing, control head and brine tankĮmpty & clean the brine tank. Install booster pump upstream of the systemĬheck manual and follow instructions to set valve lower Remove clog in brine tank, brine line or injectorĬheck control head settings or replace broken switches Regeneration cycle delayed or stuck continuously runningīrine solution not being drawn to resin tank Internal valve or distributor malfunction Verify capacity needed and replace if necessary Reset or replace control head if necessary Verify unit is plugged in and power is on
0 Comments
Leave a Reply. |